Metallized Polyester (PET)
Capacitors in PCM 2.5 mm
Special
Features
High
volume/capacitance ratio and reduced base PCM 2.5 mm Self-healing According to RoHS 2002/95/EC
Typical
Applications
For
general DC-applications e.g. By-pass Blocking Coupling and decoupling Timing
Construction
Dielectric:
Polyethylene-terephthalate (PET) film Capacitor electrodes: Vacuum-deposited Internal construction:
Encapsulation:
Solvent-resistant, flame-retardent plastic case
with epoxy resin seal, UL 94 V-0 Terminations:
Tinned wire Marking:
Colour: Red. Marking: Silver. Epoxy resin seal:
Yellow
Electrical Data
Capacitance
range: 1000 pF to 1.0 µF(E12-values on request)
Rated voltages: 50 VDC, 63VDC, 100VDC, 250VDC
Capacitance tolerances: ±20%, ±10%,
(±5% available subject to special enquiry)
Operating temperature range: -55°C to +100°C
Test specifications: In accordance with IEC 60384-2 and EN
130400 Climatic test category: 55/100/21 in accordance with IEC
Insulation resistance at +20°C:
Test
voltage: 1.6 Ur, 2 sec Voltage derating:
A voltage derating factor of 1.25% per K must be
applied from +85°C for DC voltages and from
+75°C for AC voltages. Reliability: Operational life > 300000 hours
Failure rate < 2 fit (0.5 x Ur and
40°C) Graphs:
Pull
test on leads: 10 N in direction of leads according to
IEC 60068-2-21. Vibration:
6 hours at 10...2000 Hz and 0.75mm displacement
amplitude or 10g in accordance with IEC 60068-2-6 Low air density:
1kPa = 10 mbar in accordance with IEC 60068-2-13 Bump test:
4000 bumps at 390 m/sec2 in accordance
with IEC 60068-2-29